Skip to main content
Skip table of contents

Known issue 2018.1: PO—WIP assigned to newly added line in PO if existing Line has a jobcode assigned

The following issue has been identified and subsequently replicated by MYOB Support in Exo Business version 2018.1

Before upgrading your clients please take into consideration the following issues especially if the site has specific requirements in these areas.

As always we recommend that thorough testing in a non-live environment is undertaken before commencing an upgrade.


When a line with a job code is added to PO it will set the location to the WIP on the line which is correct. Now add a second line without a job code which shows the location from header but when user saves and goes back again to the PO it shows WIP location for both PO lines.


Manually change the location


Attached to Problem ticket 155275567965 for resolution in a future release.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.